This is what is returnet on the shell when I try to synchronise one of my library on a separate server:įile „/usr/bin/seaf-cli“, line 719, in mainįile „/usr/bin/seaf-cli“, line 460, in seaf_sync Unless following commandline by commandline your tutorial, I get error at this step: More information on the client usage is available on: Beitrags-Navigation Seaf-cli init -d ~/.seafile-client # initialise seafile client with this folderĪnd sync your library: seaf-cli sync -l "the id of the library" -s "the url + port of server" -d "the folder where the library folder will be downloaded" -u "username on server" -p "password" Mkdir ~/.seafile-client # create the settings folder Now you can start the seafile client: # choose a folder where to store the seafile client settings e.g ~/.seafile-client 0-dev uuid-dev intltool libsqlite3-dev valac libjansson-dev libqt4-dev cmake libfuse-dev libssl-dev If you have dependency errors try to also install the following (however most should be only needed for the build): sudo apt-get install autoconf automake libtool libevent-dev libcurl4-openssl-dev libgtk2. These packages are created using checkinstall and following the steps on For the cli-version of the client only the first three are needed (and I have not yet tested the visual seafile-client): Make sure you have python installed: sudo apt-get -y install python2.7 python-setuptools python-simplejson python-imaging sqlite3 It is also possible to install the client in parallel to the server on the same raspberry. This article describes how to easily setup the seafile client on raspberry. Unfortunately this is not the case for the client on raspberry. For this case there are ready-to-use binaries ( ) and good tutorials how to do so. The Raspberry PI is often used as a server for seafile.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |